Kinetic Precision - PFG Stones

Dry Filament Campaign

The Quest for Dry Filament
(pfg.gg/dry)

updated 23 OCT 2024


Metal Pails for Storage

These are being evaluated and are not great for storing filament… see pouches below.


Metalized Pouches for Storage

THIS is the way to store filament! —> 20 Mylar Bags for Food Storage, 2.5 Gallon Capacity, Extra Thick 15 Mil — https://amzn.to/4hjzM7G

Data is presently being collected, but these are kicking butt!!


A paper entitled “Water Vapor Permeation in Plastics” is an eye-opening read related to the storage of filament. A worthy read!


Measurement of Humidity

Here is a hygrometer you can use as a reference standard in your operations… it costs around $30. It is an eval board for the Sensirion SHT 40 sensor. VERY good performance, extremely fast response time, accurate to 1.8% error, and useful down to 0% RH. Really.

At DigiKey, Part Number 1649-SHT4XSMARTGADGET-ND. https://www.digikey.com/en/products/detail/sensirion-ag/SHT4X-SMART-GADGET/14318392

I sell these in the store!

(I am also playing with the Adafruit Feathers, and a Sensirion SHT45 as an attached sensor. More on this to come…)


The sensational Sensirion Hygrometer…

Click HERE for the STL file of the Bracket.

Here is the STL files for the Sensirion Housing TOP, and the BOTTOM.

I sell these in the store!


A fast-change Bambu Spool Dessicant Cartridge…

Click HERE for the 3MF file for the Bambu Spool Dessicant Cartridge.

(Please note that this is a REMIX of a design by EnRiON, from the Printables.com site. Linked HERE.)

Spencer scaled up the original design from a 50mm diameter to a close fit (55mm) for the Bambu Reusable Spool. Importantly, the flange on the screw-in cap was removed and replaced with two snap-in features calibrated for the width of the Bambu Reusable Spool.

This is the indicating dessicant (silica gel) which we use and re-use: https://amzn.to/43MiQih


Adafruit ESP32-S3 Rev TFT Feather Development Stand

This are the STL files for the BACK of the stand, and the FACE of the stand (P2).

HERE is the 3mf file for Bambu, ready to print. I used Tough PLA.

The screws are SHCS, 2.0mm and 2.5mm. McMaster-Carr links added.

This is a two-piece glue-together design. I use a thickened CA glue, linked elsewhere.